Harry Bryan


PLAN #10

After Wooden Boat magazine published an article on the 16 ½’ Rambler, there was much
interest in a larger version. The 20' boat detailed in these plans is our response. Not only
longer, but 18" wider, this design will seat 4 under the protection of her hard top
awning. A sliding hatch over the helmsman allows stand up navigation when needed
while keeping the profile of the boat low enough for classic good looks.
This design has just been completed. It is expected that builders will loft the boat fully
and consult with us during building.

LOA 20’ 0”
Beam 6’ 6”
Weight (Not calculated)

Hull type: V-Bottom launch
Construction: Lap-streak cedar over oak.
Intended capacity: 1-8
Propulsion: 8-16 hp. inboard diesel

Skill needed: Intermediate or better
Lofting required: Yes. Complete lines and drive train to at least 3"= 1'.
Stem, forefoot and transom full sized.
Alternative construction: Glued lap plywood (not detailed)

Plans consist of four 18"x 24" sheets
1. Construction drawing
2. Lines and offsetts
3. Profile and plan
4. scantlings and details

Cost per set: $30.00